Kepco KLR Series Developers Guide Instrukcja Użytkownika Pobierz pdf (Strona 17)

KLR-DEV 060713 1-7

• 4 - Execution Error — 1 indicates execution error has occurred (parameter exceeded

allowable range) (see Appendix B, Table B-5 for details).

• 5 - Command Error — 1 indicates a command syntax error has occurred (see Appendix

B, Table B-5 for details).

• 6 - User Request — Not used (always zero).

• 7 - Power On — set once upon power-up, however ESE bit 7 set to 0 prevents Status

Byte bit 5 from being set.

1.2.7.4 OPERATION STATUS REGISTER SET

The Operation Status register set is comprised of condition, transition, event and enable regis-

ters (see Figure 1-2). Appendix B, PAR’s B.58 through B.61 provide detailed explanations of the

queries/commands for reading and modifying these registers as applicable; the transition regis-

ter cannot be modified.

The Operation condition registers record conditions which are a part of the instrument’s normal

operation. The definition of each of these bits (condition register) is as follows:

• 0 through 4 — Not used (always zero).

• 5 - Waiting for Trigger Summary — 1 indicates the unit is waiting for trigger

• 6 and 7 — Not used (always zero).

• 8 - Constant Voltage — 1 indicates the instrument is in constant voltage mode.

• 9 — Not used (always zero).

• 10 - Constant Current — 1 indicates the instrument is in constant current mode.

• 11 through 13 — Not used (always zero).

• 14 - Program Running — 1 indicates the program is running.

• 15 — Not used (always zero).

1.2.7.5 QUESTIONABLE STATUS REGISTER SET

The Questionable Status register set is comprised of condition, transition, event and enable reg-

isters (see Figure 1-2). Appendix B, PAR’s B.63 through B.66 provide detailed explanations of

the queries/commands for reading and modifying these registers as applicable; the transition

The Questionable Condition register (see Figure 1-1) contains status bits representing data/sig-

nals which give an indication of the quality of various aspects of the signal.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 127 128

Brak uwag

Kepco KLR Series Developers Guide Instrukcja Użytkownika Strona 17