Kepco KLR Series Developers Guide Instrukcja Użytkownika Pobierz pdf (Strona 41)

KLR-DEV 060713 3-19/(3-20 Blank)

FIGURE 3-7. MEASURING VOLTAGE AND CURRENT USING LABVIEW WITH IVI-COM DRIVER

3.5.3 CHANGING THE LIMIT MODEL

The limit model Vi is very similar to the output setting and measurement examples; it has the

identical open and close functionality. The middle three blocks set the password, then cause the

voltage limit and the current limit to be applied to the KLR. This is done using the Max Positive

Current Limit and Max Positive Voltage Limit properties. As indicated in the earlier table these

are the setting nodes that are required to change the KLR limit model.

FIGURE 3-8. SETTING THE LIMIT MODEL USING LABVIEW WITH IVI-COM DRIVER

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 127 128

Brak uwag

Kepco KLR Series Developers Guide Instrukcja Użytkownika Strona 41